Shooting; Basic Shooting Procedures - JVC Connected Cam GY-HC550U Instructions Manual

Basic Shooting
Procedures
Setting up
4
3
.
1 Supply battery or AC adapter power to the
camera recorder.
(A P35 [Power Supply] )
2 Insert the recording media
(A P48 [Recording Media] )
3 Turn on the power of the camera recorder.
Setting the [POWER ON/OFF] switch to "ON"
starts up the camera recorder in the Camera
mode to enable shooting.
4 Adjust the angle of the LCD monitor and
viewfinder.
(A P43 [Adjusting the LCD Monitor and
Viewfinder] )
5 Set [System], [Format], [Resolution],
[Frame Rate] and [Bit Rate] in [System] B
[Record Set] B [Record Format].
You can select the definition of the recorded
0
videos, file format for recording/playback,
and the video recording format on this
camera recorder.
Press the [MENU/THUMB] button to display
0
the menu screen on the LCD monitor and
viewfinder.

Shooting

1 Configure the video and audio input
4
2
1
2 Press the [REC] button to start recording to
2
Memo :
0
0
3 Check the most recently captured images.
settings.
You have to configure video settings such as
brightness adjustment (iris, gain, shutter) and
white balance adjustment in order to start
shooting. You also have to adjust the audio
input settings and audio recording level for
audio recording.
Adjusting the Brightness
0
(A P64 [Adjusting the Brightness] )
Adjusting the White Balance
0
(A P69 [Adjusting the White Balance] )
Adjusting Audio Input Settings and
0
Recording Level
(A P74 [Audio Recording] )
the recording media
The tally lamp lights up in red during recording.
Zoom Operation
0
(A P59 [Zoom Operation] )
Adjusting the Focus
0
(A P60 [Focus Operation] )
If both SD card slots A and B are loaded with
recordable SD cards in the factory default state,
pressing the [REC] button starts recording only
to the media in the selected slot.
Configuring [System] B [Record Set] B [Slot
Mode] to "Dual" enables recording to be
performed simultaneously to the SD cards in
both slots A and B.
(A P88 [Dual Rec] )
The tally lamp can be turned off in [System] B
[Tally Lamp].
Press the user button that is assigned with
0
the Clip Review function. Doing so activates
the function and plays back the most recently
captured images on the LCD monitor and
viewfinder screen.
After playback, the camera recorder returns
0
to standby mode (STBY).
(A P86 [Viewing Recorded Videos
Immediately (Clip Review)] )

Basic Shooting Procedures

55