JVC Connected Cam GY-HC550U Instructions Manual page 133

AGC Response
9 Attack Time
Sets the time to activate the limiter.
[Setting Values: Fast, RMiddle, Slow]
9 Decay Time
Sets the time to deactivate the limiter operation.
[Setting Values: Fast, RMiddle, Slow]
AGC Mode
For setting whether to link the limiter operation of
[CH1] and [CH2].
Select "Link" to link or "Separate" to separate.
[Setting Values: Link, RSeparate]
Memo :
Enabled only when both the [AUX] input terminal
0
and [INPUT1/INPUT2] input terminal are set to
"LINE" or "MIC", and CH1/CH2 of the [CH1/CH2
AUTO/MANUAL] switch is set to "AUTO".
XLR Manual Level
For setting whether to link manual audio
adjustment operation between [INPUT1] and
[INPUT2] terminals.
Select "Link" to link or "Separate" to separate.
When this item is set to "Link", adjust the recording
level using the [CH1] recording level adjustment
knob.
[Setting Values: Link, RSeparate]
Memo :
Enabled only when both the [INPUT1/INPUT2]
0
input terminals are set to "LINE" or "MIC", and
both [CH1]/[CH2] of the [CH1/CH2 AUTO/
MANUAL] selection switches are set to
"MANUAL".
When this item is set to "Link", [CH2] recording
0
level adjustment knob is disabled.
Int. Mic Separation
For setting the enhancement level of the stereo
effect of the built-in microphone.
On:
0
Enhances the stereo effect.
Off:
0
Does not enhance the stereo effect.
[Setting Values: ROn, Off]
Memo :
Both [CH1] and [CH2] selection switches are set
0
to "INT".
0
When [Int. Mic Separation] is set to "On", a
icon is displayed on the status screen (audio
input) while the function is operating.
Test Tone
For specifying whether to output the audio test
signals (1 kHz) during color bar output.
[Setting Values: On, ROff]
INPUT1/2 Wind Cut
For selecting whether to cut the low frequencies of
the audio input signals (low-cut) when the [INPUT1/
INPUT2] switch is set to "MIC" or "MIC+48V".
Set this item to reduce wind noise from the
microphone.
Both:
0
Enables low-cut on both the [INPUT1] and
[INPUT2] terminals.
INPUT2:
0
Enables low-cut on the audio of the [INPUT2]
terminal only.
INPUT1:
0
Enables low-cut on the audio of the [INPUT1]
terminal only.
Off:
0
Disables low-cut.
[Setting Values: Both, INPUT2, INPUT1, ROff]
Int. Mic Wind Cut
For selecting whether to cut the low frequencies of
the audio input signals (low-cut) from the built-in
microphone. Set this item to "On" to reduce wind
noise from the microphone.
[Setting Values: On, ROff]
133
A/V Set Menu