JVC Connected Cam GY-HC550U Instructions Manual page 93

3 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECL" B
"STBYL" (yellow text)).
The card slot status indicator remains lighted
0
in red.
Memo :
When the [CANCEL] button is pressed while the
0
camera recorder is paused (STBYL), the
display changes ("STBYL" (yellow text) B
"STBYL" (blinking yellow text) B "STBYL"
(white text)), and a "clip" is generated. The card
slot status indicator lights up in green.
4 Resume recording. (Recording 2)
Press the [REC] button again to resume
0
recording. The display changes ("STBYL"
(yellow text) B "RRECL").
The card slot status indicator remains lighted
0
in red.
5 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECL" B
"STBYL" (yellow text)).
The card slot status indicator remains lighted
0
in red.
6 Resume recording. (Recording 3)
Press the [REC] button again to resume
0
recording. The display changes ("STBYL"
(yellow text) B "RRECL").
The card slot status indicator remains lighted
0
in red.
7 Press and hold the [REC] button.
Recording stops and the display changes
0
("RRECL" B "STBYL"). A "clip" is generated.
The card slot status indicator lights up in
0
green.
8 Press the [REC] button again.
The display changes ("STBYL" B "RRECL")
0
and the card slot status indicator lights up in
red.
A new "clip" is generated from here.
0
Memo :
The following operations cannot be performed
0
while recording is paused (STBYL, yellow text).
Clip Review operation
0
(A P86 [Viewing Recorded Videos
Immediately (Clip Review)] )
Switching SD card slots
0
Switching operation mode
0
(A P24 [Operation Modes] )
Files are split into sizes of 4 GB (or 30 minutes)
0
regardless of the menu settings.
Caution :
Do not remove the SD card during recording
0
(RRECL, red text) or recording pause (STBYL,
yellow text).
To remove the SD card in the "Clip
0
Continuous" mode, press the [CANCEL] button,
check that "STBYL" (white text) is displayed and
the card slot status indicator lights up in green
before you remove the card.
To remove the SD card in the "Clip
0
Continuous" mode, press the [CANCEL] button,
check that "STBYL" (white text) is displayed and
the card slot status indicator lights up in green
before you remove the card.
When the SD card becomes full during
0
recording, recording stops and "STOP" is
displayed.
When the [POWER ON/OFF] switch is turned off
0
during recording or recording pause, recording
stops and power is cut off after a clip is
generated.
If the power is cut off due to low battery power,
0
a proper clip may not be generated.
93
Special Recording