ABB Relion 670 Series Installation And Commissioning Manual page 148

Section 13
Establishing connection and verifying the LON communication
Table 25: ADE Non group settings (basic)
Name
Operation
TimerClass
142
Table 23: Setting parameters for the LON communication
Parameter Range
DomainID 0
SubnetID* 0 - 255
Step: 1
NodeID* 0 - 127
Step: 1
*Can be viewed in the local HMI
Path in the local HMI under Main menu/Settings/General settings/
Communication/SLM configuration/Rear optical LON port
These parameters can only be set with the LON Network Tool (LNT).
Table 24: LON node information parameters
Parameter Range
NeuronID* 0 - 12
Location 0 - 6
*Can be viewed in the local HMI
Path in the local HMI under Main menu/Settings/General settings/
Communication/SLM configuration/Rear optical LON port
Values (Range) Unit
Off -
On
Slow -
Normal
Fast
Path in the local HMI under Main menu/Settings/General settings/
Communication/SLM configuration/Rear optical LON port
Table 26: LON commands
Command Command description
ServicePinMsg Command with confirmation. Transfers the node address to the LON Network Tool.
Default Unit
0 -
0 -
0 -
Default Unit
Not loaded -
No value -
Step Default
- Off
- Slow
1MRK 502 029-UEN A
Parameter description
Domain identification number
Subnet identification number
Node identification number
Parameter description
Neuron hardware identification
number in hexadecimal code
Location of the node
Description
Operation
Timer class
Installation and commissioning manual