Table of Contents
Advertisement
9.3
Web interface
9.3.1
Open the web interface
1. Start your web browser if your computer is connected to ibaClock via a bidirectional
FO connection, Ethernet or USB.
2. Enter the internet address (URL) of the device into the address line.
If connection via...
FO bidirectional
Ethernet TCP/IP interface
USB interfaces
*IP address in Flex mode
IP address in Flex mode
The automatically assigned IP address in Flex mode consists of 4 sections, e.g.
172.29.0.101.
The first two sections (172.29) correspond to the IP address of the ibaFOB-D network
adapter, the third section (0) corresponds to the number displayed in the ibaFOB-D card
in the computer *10 + link number, to which the device is connected, the fourth section
(101) is the device address + 100.
Tip
If you use the Internet Explorer as browser, it might be necessary, depending on the
security level of the Internet Explorer, to enter the address http://ibaclock_xxxxxx or,
depending on the access path, the IP based URL into the trusted pages.
The pages Network, Settings and Administration are only accessible by the administra-
tors and are password protected.
24
Manual
Then URL...
IP address, that appears in the I/O Manager of ibaPDA
in the "General" tab in the field "IP address" if the device
has been configured or automatically detected, in the
example below http://172.29.0.101.*
The resolution of the device name is not supported.
IP address of the device, e.g.
or device name
http://ibaclock_xxxxxx
IP address of the device: http://192.168.0.1.
The resolution of the device name is not supported.
Issue 1.4
ibaClock
http://192.168.1.1
Advertisement
Table of Contents
