Antenna Configuration - IBA ibaClock Manual

ibaClock is not detected
ibaClock is not detected in the Flex
ring
13.1

Antenna configuration

If you have not purchased the antenna from iba, it will still be provided with the manufac-
turer's delivery configuration.
1. Connect the antenna with the Trimble RS-422 to USB converter (included in the
starter kit) and connect these to the PC.
2. Open the Trimble Studio or the Trimble Visual Timing Studio.
3. Select "New Connection..." in the Connections menu or "GNSS Receiver" in the
drop-down field "Connect to Device".
4. In the following dialog, select the device as well as the COM port for the connec-
tion of the antenna. Also set a check mark for "Auto-detect settings" in order to
automatically identify the communication settings.
5. In the monitor dialog, now select "Configure" in the drop-down field "Receiver".
6. In the device configuration dialog, switch to the tab "Communication Port".
48
a. Select the receiver port "Port B" in the first drop-down field.
b. Now set the following parameters.
Baud rate: 115200
Parity: Odd
Data Bits: 8
Stop Bits: 1
Protocols:
Input and Output: TSIP
Manual
- Check FO connection
- FO defect
- Voltage supply is overloaded
- Firmware of the ibaFOB-D card is not up-
to-date, D3 is required at least
- ibaPDA version is not up-to-date, V6.34.0
is at least required
- ibaClock can not be run in a Flex ring.
The device needs its own link on the
ibaFOB-D card.
Issue 1.4
ibaClock