Table of Contents
Advertisement
ibaClock
7.2
Display elements
The operating status of the device is shown by colored status LEDs.
Operating state
LED Color
Run
Green
-
Yellow
Link
White
Error Red
Status of time sources
The LED of the activated time source is always the only one activated (currently GPS).
Every LED can accept the following statuses:
Status
Off
Green
Flashes green
Red
7.3
Connections
7.3.1
FO connections X10 (TX) and X11 (RX)
X11 (RX): FO receive interface
X10 (TX): FO send interface
A bidirectional FO connection is required for the connection to an ibaPDA system. A FO
card type ibaFOB-D or ibaFOB-Dexp has to be installed in the ibaPDA computer so
that data can be received and sent.
The interfaces are made for cables with 62.5/125 μm multimode fibers with ST connect-
ors. Suitable FO patch cables are available at iba.
7.3.2
Power supply X14
The 2-pin input serves for the supply of the device with DC 24 V ±10% (non regulated).
The operating voltage should be put in via the supplied Phoenix threaded coupling con-
nector. If requested, you can also order DIN rails or plug-in power supply units at iba.
Manual
State
Description
Flashes slowly
Ready for use, power supply is applied to
Flashes quickly
Programming mode, e.g. at a firmware update
Off
Out of service, no voltage supply
-
Without function
On
Valid signal at RX
Flashes
Signal at RX, but configuration deviates from the detected
signal
Off
No signal at RX
Flashes
Error message
Off
Error-free operation
Description
Time source not selected
Time source OK
Synchronization to time source or time source disrupted
Time source defective
Issue 1.4
13
Advertisement
Table of Contents
