Mounting And Dismounting; Mounting And Connecting; Dismounting - IBA ibaClock Manual

ibaClock
6

Mounting and Dismounting

6.1

Mounting and Connecting

1. Insert the DIN rail clip at the backside of the device into the upper part of the DIN rail,
then press the device downwards-backwards and let it snap into the DIN rail.
2. Then, connect the DC 24 V power supply with the correct polarity and create the
following connections:
 FO connection to the ibaPDA computer
 Or Ethernet connection to a standard computer
3. Connection of the GPS smart antenna to the "GPS X44" connection via the supplied
antenna cable. The device must be connected with the antenna via a point-to-point
connection only.
Note for the mounting of the antenna
The antenna must be installed in the outdoor area with "sight contact" to the satellites.
For the calculation of the exact time at least 4 satellites must be detected. At free sight
to the horizon, averagely 7-9 satellites are visible.
The antenna should be installed with greatest possible opening angle towards the sky. A
mounting rob for the mounting on buildings is available at iba.
Other documentation
Please find information for positioning and mounting of the antenna in the antenna man-
ual.
As a registered user you can find the manual at
6.2

Dismounting

1. First, remove all connections of the device.
2. Grasp the upper part of the device with one hand. Press the device slightly down-
wards in order to hold it safely in both hands later to prevent the device from falling
down.
3. Grasp the bottom part of the device with the other hand and pull it forwards-upwards.
Thereby, the device will get detached from the DIN rail.
Manual
www.iba-ag.com
Issue 1.4
in the download area.
11