Conformity With European Directives; Conformity With Ped Directive - Siemens SITRANS F Series Operating Instructions Manual

Safety notes

2.3 Conformity with PED directive

2.2

Conformity with European directives

The CE marking on the device symbolizes the conformity with the following European
directives:
Electromagnetic compatibili‐
ty EMC
2014/30/EU
Low voltage directive LVD
2014/35/EU
Pressure equipment direc‐
tive PED
2014/68/EU
The applicable directives can be found in the EU declaration of conformity of the specific device.
CE marked equipment
All meters carry either a CE mark or a CE mark followed by eg.200
● CE200: This indicates that the product conforms to:
– PED 2014/68/EU
– LVD 2014/35/EU
– EMC 2014/68/EU
● CE: This indicates that the product conforms to:
– LVD 2014/35/EU
– EMC 2014/68/EU
2.3 Conformity with PED directive
Instrument safety standards
The device has been tested at the factory, based on the safety requirements. In order to
maintain this condition over the expected life of the device the requirements described in these
Operating Instructions must be observed.
NOTICE
Material compatibility
Siemens Flow Instruments can provide assistance with the selection of wetted sensor parts.
However, the full responsibility for the selection rests with the customer and Siemens Flow
Instruments can take no responsibility for any failure due to material incompatibility.
12
Directive of the European Parliament and of the Council on the
harmonisation of the laws of the Member States relating to elec‐
tromagnetic compatibility
Directive of the European Parliament and of the Council on the
harmonisation of the laws of the Member States relating to the
making available on the market of electrical equipment designed
for use within certain voltage limits
Directive of the European Parliament and of the Council on the
harmonisation of the laws of the Member States relating to the
making available on the market of pressure equipment
SITRANS FM MAG 5100 W
Operating Instructions, 01/2020, A5E03063678-AC