MSTS1500-A by MacAllister
EN
Problem
The work piece is
touching the back
of the saw blade
and is jumping
out.
Saw does not
make accurate
90°or 45° cuts.
54
Possible cause
1. The fence is not being
used.
2. The saw blade is
thicker than the riving
knife or the riving knife
is not being used.
3. The blade is dull.
4. The work piece has not
been kept in its place
until after sawing.
5. Mitre gauge locking
handle is loosen.
1. Positive stops inside
the cabinet need
adjusting (Bevel cuts).
Trouble shooting
Solution
1. Use the fence.
2. Replace blade or mount
the riving knife.
3. Replace blade.
4. Keep the work piece in
place until finsh the
sawing.
5. Tighten the mitre gauge
locking handle.
1. Adjust the positive
stops.