Check Before Starting; Connection To The Electrical Supply - Mac allister MSTS1500-A Manual

MSTS1500-A by MacAllister

Check before starting!

Warning: Risk of injury!
In case of malfunctions, press the red 0-Button on the On/Off
switch [7] and pull out the mains plug.
Warning: Risk of injury!
The table saw must only be put into operation if no faults
are found. If a part is defective, it must absolutely be replaced
before the next use.
Check the safe condition of the product before plugging the power cable:
> Check whether there are any visible defects.
> Check whether all parts of the device are firmly attached.
> Check whether the safety equipment is in faultless condition.
> Check whether the saw blade can run freely.
> Check whether the bevel locking handle is locked.

Connection to the electrical supply

Before switching on, make sure that the voltage of the mains supply is the same as
indicated on the rating plate. This product is designed to operate on 220-240V~
50Hz. Connecting it to any other power source may cause damage.
Before you start
EN
33