On/Off Switch - Mac allister MSTS1500-A Manual

MSTS1500-A by MacAllister
OPERATION CONTROLS

On/Off switch

Warning: Risk of injury!
Before turning on the switch make sure the blade guard is correctly
installed and operating properly.
Switching on:
> To start the machine by pressing the green I-button [63] on the On/Off switch [7].
When turning the switch ON stand on either side of the blade and never in front
of it.
Allow saw blade to reach full speed before cutting.
Switching off:
> To stop the machine by pressing the red 0-Button [64] on the On/Off switch [7].
Overload reset switch
This saw is equipped with a overload reset switch. It is situated at the immediate
top of the On/Off switch.
The overload reset switch [9] (See Fig. 10) will restart the motor after it shuts off
due to overloading.
If the motor stops during operation, push the switch to the OFF position.
Wait approximately five minutes for the motor to cool down and push the overload
reset switch. Now you can switch to the ON position again.
9
7
63
64
Fig. 10
Product functions
EN
35