To Assemble The Stand - Mac allister MSTS1500-A Manual

MSTS1500-A by MacAllister
To attach the mitre gauge
> Push the guide rail [56] of the mitre gauge [12] into one of the guide grooves
[57] of the working table intended for this purpose.

To assemble the stand

> Secure the long & short top leg brackets [33, 34] and long & short bottom leg brackets
[35, 36] to the stand legs [37] using screws M6 x 12 [38], flat washers 6
[29], spring washers 6 [30] and hex nuts M6 [31]. Only hand-tighten the hex nuts
for the time being.
Important: There are two different sizes of parts 33, 34, 35,36 these must be
assembled opposite each other. For example part 33 must be above part 35.
Make sure that that the locking pins [a] on the stand legs must secure in the
holes (b) on leg brackets.
> Tighten all bolted connections.
> Push the rubber foot [4] onto the stand legs [37].
57
56
Fig. 6
Before you start
57
12
EN
29