Mac allister MSTS1500-A Manual page 24

MSTS1500-A by MacAllister
EN
To assemble the riving knife
> Loosen the six cross-screws [43] with the screwdriver and remove the table
insert [17]. (Fig. 3a)
> Loosen the blade bevel locking handle [10] and set the bevel angel to 0°. Tighten
the bevel locking handle [10] afterward. Turn height adjusting handle [6] anti-
clockwise to raise the blade to its highest position. (Refer to "Product functions-
bevel locking handle, bevel adjusting handwheel and height adjusting handle").
> Loosen the tri-wing knob [44] and pull large square washer [45] away from the
side of the machine. NOTE that DO NOT remove the tri-wing knob [44] and large
square washer [45].
> Insert the riving knife [3] to the left of the tri-wing knob and both washers (see
Fig. 3b). Then push the riving knife down, when you hear a "click" the pin [46]
is locked into the hole [47] on the riving knife [3].
> Push the square washer [45] onto the pin [46] and then tighten the tri-wing knob
[44]. No further adjustment to the riving knife is required.
3
46
45
Fig. 3b
24
Fig. 3a
47
3
3
44
43
46
45
44
Before you start
17
3-8 mm 3-8 mm
Fig. 3c