Mac allister MSTS1500-A Manual page 28

MSTS1500-A by MacAllister
EN
To assemble the blade guard
> Pull out and hold locking knob [52], align the pin [53] of the blade guard [14] with
the hole [54] of the riving knife [3].
> Press the blade guard [14] down and release the locking knob [52] to insert the
pin [53] into hole [54] on the riving kinfe [3] to lock the blade guard [14] in place.
Ensure the pin [55] is located at inner side of the blade guard.
> Ensure the blade guard rests on the working table but will lift when a work piece
is pushed into the working table.
28
WARNING: Risk of injury!
The saw blade guard [14] must be in position at all times
to prevent contact with the saw blade. It should lift up and onto
the work piece when the work piece is passed through the saw.
WARNING: The blade guard should return to its rest position after
the work piece has been cut.
14
Fig. 5
52
55
Before you start
54
3
52
53