Mac allister MSTS1500-A Manual page 16

MSTS1500-A by MacAllister
EN
- The manufacturer assumes no liability for any damage caused by neglect of
these operating instructions.
- Please also observe the special safety instructions in the respective chapters.
- Where applicable, follow the legal directives or regulations for the prevention
of accidents pertaining to the use of table saws.
General hazards!
- Consider environmental conditions.
- When working long stock use suitable supports.
- The saw shall only be started and operated by persons familiar with table saws
and who are at any time aware of the dangers associated with the operation of
such tools. Persons under 18 years of age shall use this machine only in the
course of their vocational training, under the supervision of an instructor.
- Keep bystanders, particularly children, out of the danger zone. Do not permit
other persons to touch the machine or power cable while it is running.
- Avoid overheating of the saw teeth.
- Only saw wedges with the appropriate auxiliary limit stop.
Risk of electric shock!
- Do not expose the machine to rain.
Do not operate the machine in a damp or wet environment.
Prevent body contact with earthed objects such as radiators, pipes, cooking stoves,
refrigerators when operating this machine.
- Do not use the power cable for any purpose it is not intended for.
Risks of personal injury and crushing by moving parts!
- Do not operate the machine without installed guards.
- Always keep sufficient distance to the saw blade. Use suitable feeding aids, if
necessary. Keep sufficient distance to driven components when operating this
machine.
- Wait for the saw blade to come to a complete stop before removing cutoffs, scrap,
etc. from the work area.
- Do not attempt to stop the saw blade by pushing the workpiece against its side.
- Ensure that the device is separated from the mains power before you transport
the machine or carry out any setting, retrofitting, maintenance or cleaning.
- Ensure that when switching on (e.g. after servicing) no tools or loose parts are
left on or in the machine.
16
Technical and legal
information