Plug Replacement - Mac allister MSTS1500-A Manual

MSTS1500-A by MacAllister
WARNING! Product damage!
When installing, make sure to heed the turning direction of the
saw blade!
NOTE: During installation, make sure that the saw blade is sitting
correctly on the arbor.
WARNING! Risk of injury!
The arbor nut may not be tightened too much. Product damage
and severe injuries may result!
> Lower the saw blade to lowest position and replace the table insert.
> Raise the saw blade to maximum height and replace the blade guard.

Plug replacement

Replacement of the plug shall always be carried out by the manufacturer of the
tool or his service organization and follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Blue – Neutral Brown – Live
As the colours of the wire in the mains lead of this product may not correspond
with the coloured marking identifying the terminals in your plug, proceed as follows.
The wire, which is coloured blue, must be connected to the terminal, which is
marked with N or coloured black. The wire, which is coloured brown, must be
connected to the terminal, which is marked L or coloured red.
23
74
73
Fig. 24
Care and maintenance
26
72
71
26
EN
49