Table of Contents
Advertisement
Automatic spray gun M14
Fig. 13: Attaching the fluid needle
5.
If necessary, insert O-rings ( Fig. 13/2 and 3) and insert separating disk ( Fig. 13/4) in con-
trol section ( Fig. 13/1).
6.
Carefully push piston ( Fig. 13/6) with needle ( Fig. 13/5) into the control section (
Fig. 13/1).
7.
Insert pressure spring ( Fig. 13/7).
8.
Screw valve seal ( Fig. 13/8) into control section ( Fig. 13/1) and tighten with fork wrench.
9.
After assembly, check the tight fit of all parts.
10.
Check moving parts to make sure they run easily.
■ 200-0153
ENGLISH
GB–33
Advertisement
Table of Contents
