Information For The User; Fcc Information (U.s.a) - Digigram AUDIOWAY BRIDGE B1 User Manual

AUDIOWAY BRIDGE B1, B2, B3

2 INFORMATION FOR THE USER

2.1 FCC INFORMATION (U.S.A)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may cause undesired
operation.
NOTE: This product has been tested and found to comply with the limits for a Class B Digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to the operation of other radio communications. Compliance with FCC regulations does not
guarantee that interference will not occur in all installations.
If this product is found to be the source of interference, which can be determined by turning the unit "OFF"
and "ON", please try to eliminate the problems by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line
filter(s).

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300
ohm ribbon lead, change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized
to distribute this type of product
IMPORTANT: When connecting this product to accessories and/or another product, use only high quality
shielded cables. Cable/s supplied with this product MUST be used.
User's Manual AUDIOWAY BRIDGE v1.0
U ' 1.0
SER S MANUAL V
Page 5/55