Audioway Bridge Remote Control With Avs-Monitor; Clock Setup - Digigram AUDIOWAY BRIDGE B1 User Manual

AUDIOWAY BRIDGE B1, B2, B3

11 AUDIOWAY BRIDGE REMOTE CONTROL WITH AVS-MONITOR

11.1 CLOCK SETUP

There are two ways to configure audio clock inside your AUDIOWAY BRIDGE:

AUDIOWAY BRIDGE is slave, and receive audio clock from Dante network

AUDIOWAY BRIDGE is master, and will feed the clock to the Dante network
11.1.1 AUDIOWAY BRIDGE SLAVE
To slave and synchronize AUDIOWAY BRIDGE to the Dante network PTP clock through the AWc-DANTE
card, please proceed as follows.
In AVS-Monitor Software, please click on the Clock source frame to access the Rack Setup Menu, and select
the clock source to be "Dante'.
Then, from the Dante Controller Software application, open the AUDIOWAY BRIDGE clock status page, and
select the clock source to be the AWc-DANTE card.
(Figure provided for AUDIOWAY BRIDGE B1)
User's Manual AUDIOWAY BRIDGE v1.0
U ' 1.0
SER S MANUAL V
Page 30/55