Sample Rate - Digigram AUDIOWAY BRIDGE B1 User Manual

AUDIOWAY BRIDGE B1, B2, B3 U ' 1.0
SER S MANUAL V

11.4 SAMPLE RATE

Whatever the B1, B2 or B3 version, AW-CORE and Dante, MADI, AES1616 interface cards can work at 48
kHz, 44.1 kHz, 88.2 or 96 kHz sample rate frequency.
If the sampling frequency is driven by the Dante interface, the working sample rate can be easily changed
using Dante Controller software. To do so, go to "Device  Device View" in Dante Controller software. A
new window will open. Select your device, and go to "Device Config" Tab.
Configure the sample rate value from the "Sample Rate" combo box. It is recommended to reboot the
interface after changing this parameter.
All the other interfaces of your AUDIOWAY BRIDGE rack must also be configured to the same sampling
frequency in order to avoid audio issues.
Please note that the "Freq" field indicates the sample rate measured by the physical interface. If this
frequency is different from AW-CORE, then the interface will not be synchronized as in the following
example:
Nota: When sample frequency is synchronized to Dante network with AES67 compatibility, the
frequency is restricted to 48 kHz.
User's Manual AUDIOWAY BRIDGE v1.0 Page 34/55