Table of Contents
Advertisement
AUDIOWAY BRIDGE B1, B2, B3
9 INSTALLATION AND CONFIGURATION WITH
INSTALLATION AND CONFIGURATION WITH AVS-MONITOR
Connect a CAT6 cable between your control PC and the PRIMARY Ethernet connector located on the
cable between your control PC and the PRIMARY Ethernet connector located on the
cable between your control PC and the PRIMARY Ethernet connector located on the
AUDIOWAY BRIDGE's AWc-Dante interface. Power your equipment and run AVS
PC.
You may need to select your PC network interface by selecting
d to select your PC network interface by selecting
Edit then Preferences/Control panel
Then turn the AVS service ON and connect it to your PC
Then turn the AVS service ON and connect it to your PC
network interface in the AVS-control panel
AVS-Monitor's auto-discovery will proceed and discover all the AUDIOWAY BRIDGE devices connected on
discovery will proceed and discover all the AUDIOWAY BRIDGE devices connected on
discovery will proceed and discover all the AUDIOWAY BRIDGE devices connected on
the same LAN as your PC.
You will be then allowed to access the following control
You will be then allowed to access the following control page of your AUDIOWAY BRIDGE
B3
Dante interface. Power your equipment and run AVS-
control panel
MONITOR
page of your AUDIOWAY BRIDGE
User's Manual AUDIOWAY BRIDGE v1.0
User's Manual AUDIOWAY BRIDGE v
U
'
1.0
SER
S MANUAL V
-Monitor on your control
Page 22/55
Advertisement
Table of Contents
