AUDIOWAY BRIDGE B1, B2, B3
11.6.6 Interface with AES67 third party devices
You first need to enable AES mode on your Dante interface, through the Dante controller
Please note Dante properties in AES67 mode:
Multicast flow only, up to 8 channels per flow.
Multicast IP addresses must be in the range [239.69.0.0 - 239.69.255.255/16]
48 kHz sampling rate only.
24 bit (L24) only for transmission and reception.
2 milliseconds fixed latency for reception.
Primary network only
100 Mbps or slower connections are not supported.
Common sense precautions should also avoid audio mishandling:
If you modify the device labels, reboot the Dante interface after label modifications to update the
AES67 signal name announcement
Apply "Clear Config" and reboot the Dante interface when enabling or disabling AES67 mode.
Do not change the bit depth (default 24 bit) from Dante Controller or the console after enabling the
AES67 mode.
User's Manual AUDIOWAY BRIDGE v1.0
U
'
1.0
SER
S MANUAL V
Page 43/55