Digigram AUDIOWAY BRIDGE B1 User Manual page 45

AUDIOWAY BRIDGE B1, B2, B3

AES67 is Multicast only : create AES67 multicast transmission streams in Device View as usual, but
tick "AES67 flow" first.

In the Routing tab on Dante Controller, the non-Dante AES67 devices will appear in blue as the
transmitters.
Clocking considerations

AES67 mode on a Dante device enables both IEEE 1588 Precision Time Protocol (PTP) v1 and v2.
A single clock domain must be created across both PTP v1 and v2 devices:

Standard Dante devices support PTP v1 only

AES67-enabled Dante devices support PTP v1 and PTP v2

AES67 devices support PTP v2 only

PTP v1 and v2 are not inter-compatible. One AES67-enabled Dante device will act as the boundary
clock between PTP v1 and v2, bridging the two clock domains
We suggest to start enabling AUDIOWAY BRIDGE as Master for both Dante and AES67.

Enable the Dante card "Preferred Master" status

Disable "Preferred Master" for all Dante devices that have AES67 disabled.

Disable "Sync to External" for all devices.

Assign a PTPv2 priority level of between 128 and 255 for all non-Dante devices
If another AES67 device (Grandmaster Clock, or another AES67 device) is the Master ,

Make sure the PTP v2 Master has a priority of between 1 and 100, and is using the "Media Profile"
clock settings.

Disable "Preferred Master" and "Sync To External" for all Dante devices.

One AES67-enabled Dante device will automatically be selected as the Boundary clock, becoming
the Dante Master.

Make sure the Master Clock device is set to use the "Media profile" (not the "Default profile" because
Dante devices do not support the Default profile.
User's Manual AUDIOWAY BRIDGE v1.0
U ' 1.0
SER S MANUAL V
Page 44/55