Digigram AUDIOWAY BRIDGE B1 User Manual page 32

AUDIOWAY BRIDGE B1, B2, B3 U ' 1.0
SER S MANUAL V
11.1.2 AUDIOWAY BRIDGE MASTER
Proceed as follows to configure AUDIOWAY BRIDGE so that it behaves as the master clock for the Dante
network.
From the AVS-Monitor software application, open the AUDIOWAY BRIDGE clock setup page, and select the
clock source to be something else than the AWc-DANTE card:
(Figure provided for AUDIOWAY BRIDGE B1)
From the Dante Controller Software application, open the Clock Status tab page, and select "External" for
the clock source.
.The "Preferred Master" parameter must be enabled (AUDIOWAY BRIDGE generates the clock to the Dante
network).
User's Manual AUDIOWAY BRIDGE v1.0 Page 31/55