Setting The Speaker Impedance And Language; Turning This Unit On And Off - Yamaha RX-Z11 Owner's Manual

Setting the speaker impedance and
language
Caution
If you are to use 6-ohm speakers, set "
"6ΩMIN" as follows BEFORE using this unit.
Before using this unit, set the speaker impedance of the connected
speakers and the language of the menu items and messages.
1
Make sure this unit is turned off.
Press and hold M PROGRAM on the front panel and
2
then press B MASTER ON/OFF inward to the ON
position to turn on this unit.
Press and hold MPROGRAM until "ADVANCED SETUP"
appears in the front panel display.
While holding
PROGRAM
PUSH ENTER
A D V A N C E D S E T U P
Rotate M PROGRAM to select "SPEAKER IMP.".
3
Press M PROGRAM repeatedly to select "8ΩMIN" or
4
"6ΩMIN".
Rotate M PROGRAM to select "LANGUAGE".
5
Press M PROGRAM repeatedly to select the desired
6
language setting.
Choices: ENGLISH (English), JAPANESE (Japanese),
FRENCH (French), GERMAN (German), SPANISH
(Spanish), RUSSIAN (Russian)
Notes
• You can also select the language setting by using GUI menu. See page 114
for details.
• Some languages are not displayed in the front panel display or Zone OSD.
LANGUAGE GUI menu
RUSSIAN
JAPANESE
Other languages
··· The selected language is displayed.
— ··· The selected language is not displayed. The menu items and
messages are displayed in English.
" to
SPEAKER IMP.
down
MASTER
Front panel
Zone OSD
display
—
— —
Press B MASTER ON/OFF to release it outward to
7
the OFF position to save the new setting and turn off
this unit.
The setting you made is reflected next time you turn on this
unit.

Turning this unit on and off

■ Turning on this unit
Press B MASTER ON/OFF on the front panel inward to
the ON position to turn on this unit.
When you turn on this unit by pressing B MASTER ON/OFF, the
main zone is turned on.
Note
After this unit is turned on, it takes approximately 20 seconds until this unit
produces sounds, and while "Please wait" appears in the front panel display,
this unit does not accepts the front panel operations and stores the remote
control operations. This unit performs the stored remote control operations
after "Please wait" disappears.
■ Turning off this unit
Press B MASTER ON/OFF on the front panel again to
release it outward to the OFF position to turn off this unit.
Notes
• A MAIN ZONE ON/OFF on the front panel as well as E POWER and
D STANDBY on the remote control are operational only when
B MASTER ON/OFF is pressed inward to the ON position.
• Basically, we recommend that you use the standby mode to turn off this
unit.
■ Set the main zone to the standby mode
Press A MAIN ZONE ON/OFF (or D STANDBY) to set
the main zone to the standby mode.
In the standby mode, this unit consumes a small amount of power in
order to receive infrared signals from the remote control.
■ Turning on the main zone from the standby
mode
Press A MAIN ZONE ON/OFF (or E POWER) to turn on
the main zone.
y
• When you turn on this unit, there will be a delay for a few seconds before
this unit can reproduce sound.
• These buttons are operational only when B MASTER ON/OFF is pressed
inward to the ON position.
If there are some problems...
• First, turn off and then turn on this unit again.
• If problems persist, initialize the parameters of this unit. See
page 154 for details.
Connections
43
En