Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Checking The Firmware Version (Version); Changing The Speaker Impedance Setting (Sp Imp.) - Yamaha R-N803 Owner's Manual

Configuring the system settings (ADVANCED SETUP menu)

Configure the system settings of the unit using the front
panel controls.
A (power)
DIMMER DISPLAY MODE
INPUT BASS
PHONES SPEAKERS USB
A B
5V 1A
YPAO MIC
DISPLAY
1
Press A (power) to turn off the unit.
2
While holding down RETURN, press A (power).
3
Rotate SELECT/ENTER to select an item.
4
Press SELECT/ENTER to select a setting.
5
Press A (power) to set the unit to turn off and
turn it on again.
The new settings take effect.

ADVANCED SETUP menu items

Item
Checks the version of firmware
VERSION
currently installed on the unit.
Changes the speaker impedance
SP IMP.
setting.
Selects the unit's remote control ID.
REMOTE ID
(Asia and General models only)
TU
Sets tuner frequency step.
Restores the default settings.
INIT
Updates the firmware.
UPDATE
52
En
RETURN
PURE DIRECT
MEMORY CLEAR BAND PRESET TUNING
VOLUME
BALANCE LOUDNESS
TREBLE SELECT
PUSH - ENTER
FLAT
-30dB
RETURN
CONNECT
L R
SELECT/ENTER
Function
Checking the firmware version
(VERSION)
VERSION••xx.xx
Check the version of firmware currently installed on the
unit.
Note
• You can also check the firmware version in "Update (Network
Update)" (p. 50) in the "Setup" menu.
• It may take a while until the firmware version is displayed.
Changing the speaker impedance
setting (SP IMP.)
SP IMP.••8¬MIN
Change the unit's speaker impedance settings depending
on the impedance of the speakers connected.
Settings
Page
52
4  MIN
52
8  MIN
(Default)
52
Selecting the remote control ID
53
(REMOTE ID)
53
53
REMOTE ID••ID1
Change the unit's remote control ID so that it matches the
remote control's ID.
Select "ID1" normally. Select "AUTO" only when you
use the remote control supplied with some Yamaha player.
Settings
ID1 (Default), AUTO
Select this option when you connect speakers with
an impedance of 4 ohms to less than 8 ohms to the
unit.
Select this option when you connect speakers with
an impedance of 8 ohms or more to the unit.