Programming Codes From Other Remote Controls (Learn) - Yamaha RX-Z11 Owner's Manual

Remote control features
Programming codes from other remote
controls (LEARN)
You can program remote control codes from other remote controls.
Use the learning feature if you want to program functions not
included in the basic operations covered by the remote control
codes, or an appropriate remote control code is not available. You
can program the function of other remote control to the buttons in
the highlighted areas in the following illustration. The buttons can
be programmed independently for each control area.
POWER POWER
TV AV
MULTI V-AUX
BD
DVD
HD DVD
CBL
DTV
SAT
TUNER DOCK
SELECT
SETUP
SYSTEM MEMORY
1 2
LEVEL
PRESET/CH
TITLE
BAND
ENTER
RETURN
MEMORY
PC/MCX
REC
NET RADIO USB
CLASSICAL 1 CLASSICAL 2 LIVE/CLUB
1 2
MOVIE STEREO
5 6
THX STRAIGHT PURE DIRECT
9 0
PARTY SLEEP
TV VOL TV CH
(U.S.A. and Canada models)
Notes
• The remote control transmits infrared rays. If the other remote control also
uses infrared rays, this remote control can learn most of its functions.
However, you may not be able to program some special signals or
extremely long transmissions. Refer to the operating instructions for the
other remote control.
• You cannot program the desired remote control code even if you select the
buttons in the highlighted area in the above illustration depending on the
selected control area and the assigned library.
1
Set the operation mode selector to FSOURCE and
then press an input selector button (3) to select the
desired control area.
The name of the control area you want to customize appears in
the display window (4) on the remote control.
y
• You can also select the desired control area by pressing 5SELECT
l / h repeatedly.
• If you want to select "TV", set the operation mode selector to FTV.
Note
Make sure that the operation mode selector is set to F SOURCE or
FTV. When you set the operation mode selector to FAMP and
program a remote control codes from other remote controls, the
programmed key cannot operate the amplifier function of this unit.
126
En
STANDBY POWER
MD
PHONO
TAPE
CD CD-R
DVR VCR
NET
XM
USB
Set to
AMP
TV
SOURCE
SOURCE
MACRO
ID
MODE ZONE
3 4
SRCH MODE VOLUME
MENU
CAT.
A-E
DISPLAY
MUTE
PRG SELECT
ENTERTAIN
3 4
ENHANCER SUR. DECODE
7 8
EXTD SUR.
10 ENT.
HDMI OUT AUDIO SEL
MUTE AUDIO
TV
3D DSP
INPUT
DVD
2
Press GSETUP using a ballpoint pen or similar
object.
"SETUP" appears in the display window (4).
SETUP
3
Press 9k / n repeatedly to select "LEARN" and then
press 9ENTER.
The remote control enters the learning mode. "LEARN" and
the name of the selected control area appears in the display
window (4) alternately.
START
4
Place this remote control about 5 to 10 cm (2 to 4 in)
apart from the other remote control on a flat surface
so that their infrared transmitters are aimed at each
other and then press 9ENTER.
"L–KEY" appears in the display window (4).
(U.S.A. and Canada
models)
5
Press the button for which you want to program the
new function.
"START" appears in the display window (4).
(U.S.A. and Canada
models)
DVD
Other remote control
5 to 10 cm (2 to 4 in)
L-KEY
START