Loading The Stored System Settings; Loading By The System Memory Buttons; Loading By The Gui Menu Operation - Yamaha RX-Z11 Owner's Manual

Saving and recalling the system settings (System Memory)

Loading the stored system settings

• Before performing the following operations, set the operation mode
selector on the remote control to F AMP.
• This unit overwrites the stored settings to the current settings of this
unit. If you do not want to erase the current settings, save the current
settings to any System Memory number in advance.
■ Loading by the
7
You can recall the system settings stored in "Memory1" to
"Memory4" by pressing the corresponding 7SYSTEM MEMORY
buttons.
y
To recall the system settings for Zone 2, Zone 3, or Zone 4, press HZONE
on the remote control repeatedly to select the operation zone setting of the
remote control in advance. You can recall the system settings for the selected
zone only when the zone is turned on.
Press one of the 7SYSTEM MEMORY buttons on
1
the remote control to select the desired memory
number.
"MEMORY 1 LOAD" (example) appears in the front panel
display.
y
"EMPTY" appears in the menu screen if no system settings are stored
in the selected memory number.
Press the selected 7SYSTEM MEMORY button
2
once more to confirm the selection.
This unit loads the settings stored in the selected memory
number.

■ Loading by the GUI menu operation

Press I MENU on the remote control.
1
The top menu appears in the video monitor.
2
Press 9k / n repeatedly to select "System Memory"
and then press 9h.
The "System Memory" menu appears in the video monitor.
3
Press 9k / n repeatedly to select the desired zone
and then press 9h.
In the following example, you select "Main" (main zone). The
list of the memory number appears in the video monitor.
Main Load
Main Save
Main Rename
Note
You can recall the system settings for the selected zone only when the
zone is turned on.
118
En
SYSTEM MEMORY buttons
Memory1
Memory2
Memory3
4
Press 9k / n to select "Main Load" and then press
9h.
The following menu appears in the video monitor.
Memory1
Memory2
Memory3
y
If system settings are already stored in the selected memory number,
the stored system parameter settings appear in the menu screen.
"Memory Empty" appears in the menu screen if no system settings are
stored in the selected memory number.
5
Press 9k / n repeatedly to select the desired
memory number where the system settings are
stored and then press 9h.
Once "Load: ENTER" appears in the video monitor, press
9ENTER to confirm the loading.
y
You can cancel the loading by pressing 9l.
Memory1
Memory2
Memory3
Press I MENU to exit from the GUI menu.
6
Main Save
Input/HDMI Out
Audio
Volume
SP Config
Video
Option
Main Save
Input/HDMI Out
Audio
Volume
SP Config
Video
Option
Save
Load: ENTER