Direct Number Access Mode; Setting The Xm™ Satellite Radio Preset Channels - Yamaha RX-Z11 Owner's Manual

XM™ Satellite Radio tuning (U.S.A. and Canada models only)

■ Direct Number Access mode

Press I SRCH MODE on the remote control
1
repeatedly to select "ALL CH SEARCH" or "CAT
SEARCH".
A L L C H S E A R C H
C A T S E A R C H
2
Press the numeric buttons (B) on the remote control
to enter the desired three-digit channel number.
For example, to enter the number 123, press the numeric
buttons as shown below.
CLASSICAL 1
1
The display changes as follows.
< X M > - - 1
< X M > - 1 2
< X M > 1 2 3
y
• To enter a one-digit or two-digit channel number, press the numeric
buttons ( B ) on the remote control and then press N ENT to confirm the
input number.
• If no button is pressed within a few seconds after you enter a one-digit or
two-digit number, this unit automatically confirms the entered channel
number.
• If you enter the number 0, this unit displays your XM Radio ID (see
page 74).
76
En
or
CLASSICAL 2 LIVE/CLUB
2 3
Before performing the following operations, set the operation mode
selector on the remote control to F SOURCE and then press 3XM.
Setting the XM™ Satellite Radio preset
channels
You can use this feature to store up to 40 XM Satellite Radio
channels (A1 to E8: 8 preset channel numbers in each of the 5
preset channel groups). You can then recall any preset channel
easily by selecting the preset channel group and number as
described in "Preset Search mode" on page 75.
1
Search for a channel you want to set as a preset
channel by using one of the XM Satellite Radio
search modes.
[ 0 4 3 ] X M U
Currently selected channel number
Press J MEMORY (or 0 MEMORY).
2
The MEMORY indicator flashes in the front panel display for
approximately 10 seconds.
Note
You must proceed to and carry out steps 3 through 5 while the
MEMORY indicator is flashing in the front panel display.
Press MPROGRAM (or 9 CAT. l / h) repeatedly to
3
select a preset channel group (A to E) while the
MEMORY indicator is flashing.
The preset channel group letter appears in the front panel
display.
C
Currently selected preset channel group
Rotate MPROGRAM (or 9 PRESET/CH k / n)
4
repeatedly to select a preset channel number (1 to 8)
while the MEMORY indicator is flashing.
The preset channel number appears in the front panel display.
C 5
Currently selected preset channel number
MEMORY
Flashes
[ 0 4 3 ] X M U
Flashes
[ 0 4 3 ] X M U
Flashes
MEMORY
MEMORY