Setting The Speaker Impedance; Turning This Unit On And Off - Yamaha RX-V1800 Owner's Manual

Setting the speaker impedance

Caution
If you are to use 6-ohm speakers, set "SPEAKER
IMP." to "6Ω MIN" as follows BEFORE using this
unit. You can also use 4-ohm speakers as the front
speakers.
1
Make sure this unit is turned off.
Press and hold O STRAIGHT on the front
2
panel and then press A MASTER ON/OFF
inward to the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
down
STRAIGHT
EFFECT
Rotate the N PROGRAM selector to select
3
"SPEAKER IMP.".
Press O STRAIGHT repeatedly to select
4
"6Ω MIN".
Press A MASTER ON/OFF to release it
5
outward to the OFF position to save the new
setting and turn off this unit.
Note
The setting you made is reflected next time you turn on this unit.

Turning this unit on and off

Press A MASTER ON/OFF on the front panel
inward to the ON position to turn on this unit.
When you turn on this unit by pressing A MASTER ON/
OFF, the main zone is turned on.
y
When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
Press A MASTER ON/OFF on the front panel
again to release it outward to the OFF position to
turn off this unit.
Notes
• B MAIN ZONE ON/OFF on the front panel as well as
8 POWER and 7 STANDBY on the remote control are
MASTER
operational only when A MASTER ON/OFF is pressed
inward to the ON position.
• Basically, we recommend that you use the standby mode to turn
off this unit.
Press B MAIN ZONE ON/OFF (or 7 STANDBY)
to set the main zone to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
Press B MAIN ZONE ON/OFF (or 8 POWER) to
turn on the main zone.
y
• When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
• These buttons are operational only when A MASTER ON/
OFF is pressed inward to the ON position.
If there are some problems...
• First, turn off and then turn on this unit again.
• If problems persist, initialize the parameters of this
Turning on this unit
Turning off this unit
Set the main zone to the standby mode
Turning on the main zone from the
standby mode
unit. See page 124 for details.
Connections
33
En