Yamaha RX-Z11 Owner's Manual page 104

Graphical user interface (GUI) menu
■ Parametric EQ (Parametric equalizer)
Use this feature to adjust the parametric equalizer of each speaker.
Dynamic Range
S-Wave Control
Parametric EQ
Tone Control
Lipsync
PEQ Data Copy (Parametric equalizer data copy)
Use this feature to copy the result data of the automatic setup to the
manual configuration area. You can select the parametric equalizer
type applied to the copied result data of the automatic setup. See
page 50 for the descriptions of each parametric equalizer type.
Choice
Flat → Manual
Copies the result of the automatic setup that the "Flat"
type parametric equalizer is applied to.
Front → Manual
Manual Copies the result of the automatic setup that the
"Front" type parametric equalizer is applied to.
Natural → Manual
Copies the result of the automatic setup that the
"Natural" type parametric equalizer is applied to.
PEQ Select (Parametric equalizer type select)
Use this feature to select the parametric equalizer type that applied
to the results of the automatic setup. See page 50 for the
descriptions of each parametric equalizer type.
Choice
Manual
Applies the manually configured parametric equalizer in
"Manual Setup".
Flat Applies the "Flat" type parametric equalizer.
Front Applies the "Front" type parametric equalizer.
Natural Applies the "Natural" type parametric equalizer.
Through Does not use the parametric equalizer.
Notes
• When you carry out the automatic setup, this unit automatically set "PEQ
Select" to "Natural".
• "Speaker Level" settings (see page 102) also changes corresponding to the
setting of "PEQ Select".
• This unit does not change the configurations of "Manual" even if you
perform the automatic setup.
104
En
Subwoofer L
Subwoofer R
Test Tone
PEQ Data Copy
PEQ Select
Descriptions
Descriptions
Manual parametric equalizer configuration of each
speaker
Use this feature to adjust the tonal quality of each speaker. You can
copy the results of the automatic setup for the base of the manual
configuration by using "PEQ Data Copy". Set "PEQ Select" to
"Manual" in advanced.
1
Press 9 k / n / l / h to select "Test Tone" or the
speaker you want to adjust.
Choice
Front L
Front R
Center
Surround L
Surround R
Surround Back L
Surround Back R
Front Presence L
Front Presence R
Rear Presence L
Rear Presence R
Subwoofer L
Subwoofer R
Test Tone
Use this feature to select whether to turn on or off the test tone
output while you are adjusting the tonal quality of each
speaker.
Choice
On Outputs the test tone.
Off Does not output the test tone.
2
Press 9 h to access the settings window.
PEQ Data Copy
PEQ Select
Front L
Front R
Center
3
Press 9 k / n / l / h to select "PARAM" and then
press 9 ENTER to select a parameter from "Band"
(band), "Freq." (frequency) or "Q" (Q factor).
y
You can adjust "Gain" (gain) with any parameter.
Adjusted speaker
Front left speaker
Front right speaker
Center speaker
Surround left speaker
Surround right speaker
Surround back left speaker
Surround back right speaker
Front presence left speaker
Front presence right speaker
Rear presence left speaker
Rear presence right speaker
Subwoofer left
Subwoofer right
Functions
PARAM RESET
EDIT EXIT
Band/Gain