Table of Contents
Advertisement
Available languages
Available languages
V1.0
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents:
•
•
GUIDE D'IDENTIFICATION
A
Saw Blade
B
Blade Guard
C
Chuck Cover
D
Saw Body
E
Throttle Lever
F
Air Inlet
ASSEMBLY & INSTALLATION
When this manual refers to a part number, it refers to the included Parts List.
INSTALLING AIR PLUG
Prepare a standard 1/4 in. NPT male air plug for use with your tool.
1.
Wrap the external threads of the male air plug with sealant tape.
a.
Wrap the tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2.
Screw the air plug into the tool's air inlet and tighten with a wrench until
snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
BLADE GUARD INSTALLATION
The air reciprocating saw comes with a long and
short blade guard. Select the blade guard that is
appropriate for the task.
1.
To install or replace the blade guard (Fig. 1-
1), use the 2 mm hex key wrench (Fig. 1-2)
to loosen the set screws (Fig. 1-3).
2.
Insert the blade guard (#34 or 50).
3.
Tighten the set screws using the hex key wrench.
Visit www.princessauto.com for more information
Air Reciprocating Saw
Reciprocating Saw • Blades (2)
Blade Guard
• Air Plug
• Hex Key (2)
8843518
Fig. 1
9
Advertisement
Table of Contents
