Table of Contents
Advertisement
Available languages
Available languages
V1.0
INTRODUCTION
The Air Reciprocating Saw cuts through copper, sheet metal, aluminum and plastic.
SAFETY
WARNING! Read and understand all instructions before using this tool. The
operator must follow basic precautions to reduce the risk of personal injury
and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating or inspection and
maintenance instructions.
WORK AREA
1.
Operate in a safe work environment. Keep your work area clean, well lit
and free of distractions.
2.
Keep anyone not wearing the appropriate safety equipment away from the
work area.
3.
Store tools properly in a safe and dry location. Keep tools out of the reach
of children.
4.
Do not install or use in the presence of flammable gases, dust or liquids.
PERSONAL SAFETY
WARNING! Wear personal protective equipment approved by the Canadian
Standards Association (CSA) or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
1.
Always wear impact safety goggles that provide front and side protection
for the eyes. Wear a full-face shield if your work creates metal filings or
wood chips.
a.
Eye protection equipment should comply with ANSI Z87.1 standards.
2.
Wear gloves that provide protection based on the work materials or to
reduce the effects of tool vibration.
3.
Non-skid footwear is recommended to maintain footing and balance in the
work environment.
4.
Steel toe footwear or steel toe caps to prevent injury from falling objects.
5.
Wear protective clothing designed for the work environment and tool.
6.
Wear a NIOSH approved respirator when working on materials that
produce dust or particulate matter.
Visit www.princessauto.com for more information
Air Reciprocating Saw
8843518
3
Advertisement
Table of Contents
