Table of Contents
Advertisement
Available languages
Available languages
9095746
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
BLADE INSTALLATION
WARNING! Do not use a stationary band saw blade for the portable band
saw. The stationary band saw blade is a different thickness and will not fit
the precision blade guides on the portable band saw.
CAUTION! Wear gloves when handling the saw blade during installation or
removal to avoid cuts from the blade' s teeth.
1.
Remove the battery from the port (D).
2.
Use band saw blades of the correction dimension (see Specifications).
3.
Select a blade that will allow at least two teeth to engage the material.
a.
Harder materials require finer blade teeth, while thicker or coarse
materials require coarser blade teeth.
b.
Hi-speed steel blades stay sharp longer than alloy steel blades.
4.
Turn the tension handle (A) clockwise to release the blade tension.
5.
Turn the band saw over so the rear side is facing up.
6.
Remove the old blade if replacing it.
7.
Note the direction arrows on the wheels. Install the saw blade so the teeth
point to the left side (clockwise) when passing through the guide
8.
Set the blade between both guide bearings, ensuring the blade is centered
on each. Hold the blade on the guides and push in to seat it.
9.
Wrap the blade around the wheels. Ensure it is a proper fit and the blade
does not twist.
10. Reinstall the blade cover. Make sure the blade cover locks are set.
11.
Tighten the tension handle (A) to secure the blade in place.
12
20V Li-Ion Cordless Brushless Compact Band Saw
For technical questions call 1-800-665-8685
V1.0
bearings.
Advertisement
Table of Contents
