Adjustments; Angel; Laser - Holzmann KG 305JL User Manual

15.2 Adjustments

15.2.1 Angle
Tilt adjustment:
 Loosen the fixing knob tilt (1).
 Set the saw arm in order that the tilt angle
indicator points exactly at 0° of the measuring
scale.
 Fix the saw arm in this position by tightening the
fixing knob.
 Bring the saw arm into the lower position and lock
it with the stop latch knob
 Attach an exact angle measuring device to saw
blade side and ground plate. They should have an exact angle of 90°.
If not, then you need to adjust the 0° of the saw arm by adjusting it with the saw arm
adjustment screws (3, 4). Repeat the procedure until 0° on indicator is exactly 90° between saw
blade and ground plate
Swing angle adjustment:
 Loosen the miter lock, operate the positive stop
locking lever and swing the saw arm aggregate to the
0° position, let it click into place. You can see the
angle at the measuring scale.
 Swing the saw arm into the lowest position (by
pushing the safety lock lever blade guard) and lock it
with the stop latch knob.
 Attach an exact angle measuring device to saw blade
side and the fence (2). They should have an exact
angle of 90°
If not, you need to adjust the back fence guide with the
back fence adjustment screws (1,3) so that angle
between saw blade and fence equals 90°.

15.2.2 Laser

The Laser marks the cutting line. After having set all angles and cutting depth, you should fine-
tune your laser.
Attach the workpiece to the back fence, fix it with the downholder.
Perform a slot cut on the workpiece so that it gets not cut through entirely.
Now turn on the laser (Laser ON/OFF Switch) and check if the laser beam marks exactly the real
cutting line.
If not you need to adjust the whole laser assembly until laser indication matches exactly the
actual cutting line.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
31
KG 305JL