Led - Feig Electronic OBID i-scan ISC.PRHD102 Installation Manual

®
OBID i-scan UHF

3.3. LED

The Reader's LED can be configured through software.
Table 2: Standard configuration of the LEDs
Abbreviation
LED green
LED blue
LED red
LED orange
LED violet
(red & blue)
FEIG ELECTRONIC GmbH
Installation
"RUN "
- Turns on when the Reader is ready.
- Flashes during Bluetooth initialization and connection establishment.
(only ID ISC.PRHD102-B)
„TRANSPONDER"
- Turns on when a Transponder is detected.
„WARNING"
- Signals a warning
- Turns on if battery voltage is flat
(no more scanning possible - only ID ISC.PRHD102-B)
„INITIALIZING " and „WARNING"
- Flashes during Reader initialization after power-up.
- Turns on if battery voltage is too low
(rechargeable battery must be charged –
only ID ISC.PRHD102-B)
„INITIALIZING internal Bluetooth interface"
- Turns on during writing Bluetooth parameters in internal
Bluetooth interface.
Page 10 of 23
Description
ID ISC.PRHD102
M80601-4e-ID-B.docx