Control And Display Elements; Signal Buzzer; Scan - Button - Feig Electronic OBID i-scan ISC.PRHD102 Installation Manual

®
OBID i-scan UHF

3. Control and Display Elements

LED

3.1. Signal buzzer

The signal buzzer can be configured by the software.
In the standard configuration the signal buzzer will be active if a Transponder is recognized.

3.2. Scan - button

The switch of the reader can be configured by the software.
In the standard configuration the serial number of the Transponder is read and is sent to the host
after pressing the scan - button.
FEIG ELECTRONIC GmbH
Installation
Figure 2: Control and Display Elements
Page 9 of 23
ID ISC.PRHD102
Scan-button
M80601-4e-ID-B.docx