Utility Job Mode - Yamaha MOTIF6 Owner's Manual

Utility Job mode

● [F6]-[SF2] Plug-in board MIDI
From this display you can set various MIDI-related
parameters for the Plug-in board.
• DevNo (Device Number)
Determines the MIDI Device Number of the Plug-in
Board. This number must match the Device Number of the
external MIDI device when transmitting/receiving bulk
data, parameter changes or other system exclusive
messages to/from it.
❏ Settings
1~16, all, off
• PORT NO. (Port number)
Determines the MIDI Port number over which the Plug-in
board receives MIDI data.One port can be set for the
Multi-part Plug-in board and two ports can be set for the
Single part Plug-in board.
❏ Settings
off, 1~3
n The Port number for the Effect Plug-in board (VH)
is fixed to 1.
• GM/XG
Determines whether "GM on" and "XG on" messages are
recognized (on) or not (off) . This parameter is available only
when the Multi-part Plug-in board has been installed to slot 3.
❏ Settings
on, off
● [F6]-[SF3] Plug-in board
Native System Parameters (Slot 1)
From this display you can set the Native System
parameters of the Plug-in board installed to slot 1.
For details on these parameters, refer to the owner's
manual of your particular Plug-in board.
● [F6]-[SF4] Plug-in board
Native System Parameters (Slot 2)
From this display you can set the Native System
parameters of the Plug-in board installed to slot 2.
For details on these parameters, refer to the owner's
manual of your particular Plug-in board.
● [F6]-[SF5] Plug-in board
Native System Parameters (Slot 3)
From this display you can set the Native System
parameters of the Plug-in board installed to slot 3.
For details on these parameters, refer to the owner's
manual of your particular Plug-in board.
260
MOTIF Reference
Utility Job mode
In this Mode, you can restore your MOTIF's User
memory (SRAM, see page 64 ) to the factory default
settings (Factory Set).
When you restore the factory default settings, all the
current settings for all the User voices and
performances on the User Memory will be overwritten
with the factory defaults.
Make sure you are not overwriting any important data.
You should back up any important data to memory
card/SCSI device beforehand.
◆ Factory Set (Restore Factory
Defaults)
1
In the Utility mode, press the [JOB] button to enter
the Utility Job mode.
2
Press the [ENTER] button. (The display prompts
you for confirmation.)
3
Press the [INC/YES] button to execute the Job.
After the Job has been completed, a "Completed"
message appears and operation returns to the
original display.
n To cancel the Job, press the [DEC/NO] button.
4
Press the [UTILITY] button to exit from the
Utility Job mode back to the Utility mode.
n All settings in the Utility mode that are related to
the Plug-in boards and the mLAN8E are stored
only to the memory on those respective devices,
and not to the User memory of the MOTIF.
Because of this, the Factory Set operation cannot be
used to restore settings for those devices.