Sample Voice
Assigned to a
specified key
Sequence data
n Detailed settings (meter, measure number etc,) are
specified in the Slice display after sampling.
• Source
Determines the recording source.
❏ Settings
A/D
Analog audio from the A/D INPUT jacks or mLAN
terminal (with optional mLAN8E) is recognized as the
recording source.
resample
The signal (already recorded sample or preset wave)
output from the MOTIF's OUTPUT jacks is recognized as
a recording source and “resampled”.
Digital
Digital audio from the DIGITAL IN terminal or OPTICAL
IN terminal (with optional AIEB2) is recognized as the
recording source.
• Mono/Stereo
Determines whether new samples will be recorded as
stereo or mono samples.
❏ Settings
monoL
The L-channel signal will be recorded as a mono sample.
monoR
The R-channel signal will be recorded as a mono sample.
monoL+R
The L-channel and R-channel signals will be mixed and
recorded as a mono sample.
stereo
A stereo sample will be recorded.
• Frequency (Sampling Frequency)
Specifies the sampling frequency. The rate at which digital
readings are taken is referred to as the sampling frequency.
Higher sampling frequencies result in higher quality sound.
❏ Settings
44.1k (44.1 kHz), 22kLo (22.05 kHz Lo-Fi), 11kLo
(11.025 kHz Lo-Fi), 5kLo (5.5125 kHz Lo-Fi)
n When the Source is set to A/D and the mLAN
terminal is used as an analog input, the Frequency
is fixed to 44.1 kHz and cannot be changed.
n At settings other than 44.1 kHz, the sound
monitored during recording may be different from
the recorded sound, depending on the source
signal.