Yamaha MOTIF6 Owner's Manual page 278

Display Messages
Messages
Plug-in 1 type mismatch.
Plug-in 2 type mismatch.
Plug-in 3 type mismatch.
PLG100 not supported.
mLAN network error.
mLAN connection error.
mLAN now in Mixer mode.
mLAN error (xxx).
Copy protected.
Digital in unlocked.
Too many favorites
Executing...
Now working...
Now loading... (xxxx)
Now saving... (xxxx)
Now checking plug-in board.
Recording stopped.
Receiving sample...
Transmitting sample...
MIDI bulk receiving...
MIDI bulk transmitting...
Completed.
Becomes valid after power on.
Scene stored
Mixing stored
Are you sure ? [YES]/[NO]
Overwrite? [YES]/[NO]
Can't undo. OK? [YES]/[NO]
278
MOTIF Appendix
The User Voice created by using the Plug-in board previously installed to slot 1 (but now removed from slot 1) has been
selected.
The User Voice created by using the Plug-in board previously installed to slot 2 (but now removed from slot 2) has been
selected.
The User Voice created by using the Plug-in board previously installed to slot 3 (but now removed from slot 3) has been
selected.
The Plug-in All Bulk Save function does not apply to the PLG100 series boards.
Indicates a problem in the mLAN8E network. Check the on/off status of the LED lamps on the mLAN8E and refer to the
Owner's Manual of the mLAN8E.
Indicates a problem in the mLAN8E connection. Check the on/off status of the LED lamps on the mLAN8E and refer to
the Owner's Manual of the mLAN8E.
The mLAN8E board is set to the Mixer mode by your computer, and the MOTIF cannot control the mLAN8E.
Indicates an unspecified problem related to the mLAN8E.
You have attempted to export or save a copy-protected digital audio source.
Digital input signal of the AIEB2 is unlocked.
You've attempted to assign more than 256 voices to the Favorite category.
A format operation or job is being executed. Please wait.
Indicates that the MOTIF is currently engaged in some operation, such as writing to/reading from the disk, etc.
Indicates that a file is being loaded.
Indicates that a file is being saved.
The MOTIF is checking the Plug-in board installation status when powering the MOTIF on.
The Song/Pattern (phrase) recording is automatically stopped because the memory becomes full.
The MOTIF is receiving sample data from Wave Editor.
The MOTIF is transmitting sample data to Wave Editor.
The MOTIF is receiving MIDI bulk data.
The MOTIF is transmitting MIDI bulk data.
The specified load, save, format, or other job has been completed.
The newly entered SCSI ID number will take effect only by turning the power of the MOTIF off and on again.
A Song scene has been stored.
In the Song/Pattern mode, the Mixing settings have been automatically stored.
Confirms whether you want to execute a specified operation or not. Press [INC/YES] or [DEC/NO] as required.
A save operation will overwrite data on the Memory card or SCSI disk, and this message confirms whether it is OK to
continue or not. Press [INC/YES] or [DEC/NO] as required.
When some jobs of the Song/Pattern are executed, the internal memory becomes full and undo cannot be used. Press
[INC/YES] if this is OK, or [DEC/NO] to abort the operation. Try again after erasing unwanted songs, patterns, or user
phrases.
Information