Yamaha MOTIF6 Owner's Manual page 136

Voice Edit mode
● [F5]-[SF2] Normal Common LFO Delay
From this display you can set various delay and
fade-in/-out parameters, and give the LFO a more
natural sound.
• DelayTime
Determines the delay time before the LFO comes into
effect. A higher value results in a longer delay time.
❏ Settings
0 ~ 127
Short delay
Key on
• FadeInTime
Determines the amount of time for the LFO effect to fade
in (after the Delay time has elapsed). A higher value
results in a slower fade-in.
❏ Settings
0 ~ 127
Max
Low FadeIn value
Faster fade-in
Delay
Key on
Max
High FadeIn value
Slower fade-in
Delay
Key on
• HoldTime
Determines the length of time during which the LFO is
held at its maximum level. A higher value results in a
longer Hold time.
❏ Settings
0 ~ 127
Max
136
MOTIF Reference
Long delay
Key on
FadeIn
Time
FadeIn
Time
Hold
Time
• FadeOutTime
Determines the amount of time for the LFO effect to fade
out (after the Delay time has elapsed). A higher value
results in a slower fade-out.
❏ Settings
0 ~ 127
Hold
Max
Low FadeOut value
Faster fade-out
Hold
Max
High FadeOut value
● [F5]-[SF3], [SF4], [SF5] Normal Common LFO
Destination 1, 2, 3
From this display you can select the destination
parameter for the LFO (which aspect of the sound
the LFO controls), the elements to be affected by the
LFO, and the LFO Depth. Three Destinations can
be assigned, and you can choose from several
parameters per Destination.
• ElemSw (Element Switch)
Determines whether or not each element is to be affected
by the LFO. The element number (1- 4) is shown when the
LFO is enabled; a dash (-) indicates the LFO is disabled for
that element.
• Dest (Destination)
Determines the parameters which are to be controlled
(modulated) by the LFO Wave.
❏ Settings
AMD, PMD, FMD, RESO (Resonance),
PAN, ELFOSpd (Element LFO Speed)
• Depth
Determines the LFO Wave Depth.
❏ Settings
0 ~ 127
FadeOut
Time
FadeOut
Time