Yamaha MOTIF6 Owner's Manual page 254

Utility mode
• Freq (Frequency)
Set the center frequency. Frequencies around this point
are attenuated/boosted by the Gain setting.
❏ Settings
LOW (Low range)
LOW MID (Low middle range)
100Hz~10kHz
MID (Middle range)100Hz~10kHz
HIGH MID (High middle range)
100Hz ~10kHz
HIGH (High range)500Hz~16kHz
• Gain
Determines the level gain for the Frequency (set above), or
the amount the selected frequency band is attenuated or
boosted.
❏ Settings
-12dB~0dB~+12dB
• Q (Frequency Characteristic)
This varies the signal level at the Frequency setting to
create various frequency curve characteristics.
❏ Settings
0.1~12.0
● [F3]-[SF2] Voice Arpeggio Channel
From this display you can set parameters related to
output of the Arpeggio MIDI data.
• OutputSwitch
This enables or disables MIDI data output for the
Arpeggio function. When this is set to "on," Arpeggio
data is sent via MIDI — allowing you to send the Arpeggio
data to an external sequencer or play back the Arpeggios
on connected MIDI tone generators.
❏ Settings
on (enable), off (disable)
• TransmitCh (Transmit channel)
Determines the MIDI channel through which Arpeggio
playback data will be sent (when Output Switch above is
on).
❏ Settings
1~16
● [F3]-[SF3] Voice Controller Assign
Sets the parameters related to the controllers in the
Voice mode.
Details about each parameter are same as in
Performance Common Edit. See page 169 .
Knob Assign 1, 2
Breath Controller
❏ Settings
off, 0~95
254
MOTIF Reference
Peaking 63Hz ~ 2.0kHz
Shelving 32Hz ~ 2.0kHz
Foot Controller 1, 2
[F3] Sequencer settings
These special song- and pattern-related settings are
available only when entering the Utility mode from the
Song or Pattern mode.
● [F3]-[SF1] Sequencer Click (MIDI Click)
From this display you can set the parameters related
to the click sound (metronome) that is used during
recording or playback in the Song/Pattern mode.
• Mode
Determines whether and when the metronome click will
sound.
❏ Settings
off, rec, rec/play, all
off
The click will not sound.
rec
The click will sound during recording only.
rec/play
The click will sound during recording and playback.
all
The click will always sound.
• Beat
Determines on which beats the metronome click will
sound.
❏ Settings
16 (16th notes), 08 (8th notes), 04 (quarter
notes), 02 (half notes), 01 (whole notes)
• Volume
Determines the click sound volume.
❏ Settings
0~127
• Rec Count
Sets the number of count-in measures provided before
actually recording starts after pressing the [F] button in
the Record standby mode .
❏ Settings
off (Recording starts as soon as the [F]
button is pressed ), 1meas~8meas
n Since the click sound is created with the internal
tone generator, using click playback affects the
overall polyphony of the MOTIF.