Thermo Scientific Accela 600 Hardware Manual page 65

Thermo Scientific
Figure 26. LED cable connection
6. Using a #2 Phillips head screwdriver, remove the four screws that secure the pump chassis
to the enclosure (see
To continue installing the dynamic mixer, go to the next procedure
Dynamic Mixer to the Pump's Front Panel."
Tip The seal wash pump and leak sensor installation procedures also require the removal
of the pump chassis from the enclosure. However, removing the chassis from the enclosure
is not the first step in these procedures.
If you are installing one of these other upgrade options, do the following:
• To continue installing the seal wash pump, go to
• To continue installing the leak sensor, go to
LED cable connection to the pump's left door
Figure 25 on page 40), and then pull the chassis out of the enclosure.
3
Dynamic Mixer Installation
"Connecting the
step 4 on page 52.
step 6 on page 55.
Accela 600 and 1250 Pump Hardware Manual
Hardware Upgrades
41