Connector Assembly - Evenflo Triumph Owner's Manual

Forward-facing Installation
Using the Lower Anchor

Connector Assembly

LATCH is a system for attaching the child restraint to your
vehicle seat. It is to be used in place of your vehicle's seat
belts, and can be used in vehicles with LATCH anchors. Your
vehicle owner's manual may refer to this system as ISOFIX
or Universal Anchorage System (UAS).
WARNING
• ONLY use for securing child restraint to vehicle lower
anchor bars.
• ALWAYS read and follow exactly the instructions that
accompany your vehicle and child restraint.
• NEVER attach two lower anchor connector hooks to one
vehicle lower anchor bar.
• DO NOT use the vehicle seat belts to install a child re-
straint when using the lower anchor connector assembly.
• This lower anchor connector assembly is intended to be
used ONLY as described in these instructions. Serious injury
or death may result from misuse.
• ALWAYS be sure that the lower anchor connector hook
is fully engaged onto the vehicle lower anchor bar by pull-
ing hard on the lower anchor connector strap. If it
is not totally engaged, the lower anchor connector
assembly will not secure your child restraint. Serious injury
or death may result.
• To avoid a strangulation hazard, you
unused lower anchor connector assembly, with all slack
removed, in storage area on the back of the seat. Roll or
fold excess lower anchor connector strap and secure with a
rubber band to prevent serious injury to vehicle occupants.
DO NOT Install by this
method for a child weighing
more than 22.7 kg (50 lb.).
MUST store the
32
WARNING
• In addition to these instructions, read and follow your
vehicle owner's manual regarding installation of the child
restraint and LATCH. If there is a discrepancy,
follow your vehicle owner's manual.
Know Your Lower Anchor
Connector Assembly
The lower anchor connector assembly that comes with your
child restraint will be one of the two types below.
SecureRight™
Adjuster
Hook
Strap
SecureRight™
1
A
C
Remove two lower anchor connector hooks
, from the the base .
B C
Lower Anchor Connector
2
Strap in Forward-facing
Position
E
Remove the seat pad from the seat shell (page 43).
Loosen harness straps
D
the way, as shown.
• If your lower anchor connector strap
in the forward- facing position (back openings),
proceed to step 6.
• If your lower anchor connector strap
facing position (front openings), continue to step 3.
Quick Connector™
Strap
Clip
Adjuster
Quick Connector™
B
, or clips
A
Lower Anchor Connector Strap
in Rear-facing Position
D
E
(page 40) and place them out of
is already
E
is in the rear-
E
33
C
D