Evenflo Triumph Owner's Manual page 11

4
D
C
belt path , the vehicle belt is not tight enough, and
C
you need to try again, or install with the lower anchor
connector assembly (p. 20). After your vehicle seat belts
are fastened, hook the seat pad back into place.
5
Locking Clip
installed properly
13 mm
(0.5 inch)
If your vehicle is model year 1996 or newer, it likely
has a vehicle belt system that can be locked when
tightened, and will not require use of a Locking Clip.
Consult your vehicle owner's manual before
installing a locking clip.
If your vehicle requires a Locking Clip, please call
ParentLink (see back cover) to obtain a Locking Clip and
instructions on how to install and use it.
WARNING
Remove Locking Clip from vehicle seat belt when not used
with a child restraint, or the vehicle seat belt will not properly
restrain an adult or child. Serious injury could occur.
The seat belt must be as
tight as possible. Put your
full weight into the child
restraint as you tighten the
seat belt .
D
If you can move the child
restraint more than 25 mm
(1 in.) side to side or front
to back at the rear-facing
Install Locking Clip,
if necessary.
If your vehicle was built
prior to model year
1996, and has either a lap
belt or lap/shoulder belt
that is equipped with an
emergency locking
retractor (ELR), you MUST
use a Locking Clip. Check
your vehicle owner's
manual to identify which
vechicle belt system is in
your vehicle.
18
6
C
WARNING
• If vehicle seat belts are not routed and fastened
correctly, the child restraint may not protect your
child in a crash.
• DO NOT use this child restraint if it moves more than
25 mm (1 in.) side to side or front to back at the rear-
facing belt path. Serious injury or death may result from
poor installation. If you can not tightly secure the child
restraint, try again or move it to another location, or
install with the lower anchor connector assembly.
Check your work.
Make certain the belts are tight. If you can move the child
restraint more than 25 mm (1 inch) side to side or front
to back at the rear-facing belt path
not tight enough. If you have not tightly secured the child
restraint, try again, move it to another location, or install
with the lower anchor connector assembly (p. 20).
WARNING
7
• To avoid a strangulation hazard, you
fold excess tether strap and secure with the strap/rubber
band.
• Attach the tether hook to the storage clip when not in
use. This will keep an unused tether from hitting someone
during a crash.
E
C , the vehicle belt is
MUST tightly roll or
When the tether strap is
not in use, you MUST
attach the hook to the
E
back of the child restraint,
and tightly roll and secure
the strap with the strap/
rubber band.
A loose tether strap and
hook may injure your
child.
19