Evenflo Triumph Owner's Manual page 28

4
F
D
A
The aircraft seat belt A must be as tight as possible. Route
the excess seat belt strap
belt path opening, as shown above. Using your full
D
weight, push the child restraint firmly onto the aircraft
seat while pulling on the excess seat belt strap to tighten.
Check your work. Reconnect the seat pad to the front
of the child restraint. Try to move the child restraint in
all directions. If you can move the restraint more than 25
mm (1 inch) side to side or front to back at the rear-facing
belt path , the aircraft seat belt
D
and you MUST install again until the seat belt is tight.
back through the rear-facing
F
is not tight enough,
A
52
Installing Child Restraint
Forward-facing in Aircraft
1
IMPORTANT: Before installing the child restraint,
make sure the aircraft seat is in a fully
upright position.
B
C
A
2
D
Route the aircraft seat belt
belt path opening in the back of the child restraint
D
and continue through the belt path opening on the
opposite side of the child restraint.
Note: Lift the restraint's seat pad away for easier access.
Unbuckle the aircraft seat
belts and lay over the
A
armrests, as shown.
Adjust the child restraint
to its upright position
(page 26), then place it
on the aircraft seat
C
forward-facing.
A
through the forward-facing
A
53
B