Evenflo Triumph Owner's Manual page 19

3
E
Remove the lower anchor connector strap
rear-facing position (front openings).
4
Crossing your arms, insert the ends of the lower anchor
connector strap in the forward-facing belt path
E
openings, as shown (back openings). Note: Make sure
the adjustment buckle
F
correct side of the child restraint, as shown.
5
E
After the lower anchor connector strap
correctly inserted, it will appear as shown above.
Note: Make sure the adjustment buckle
correct side of the child restraint, as shown.
from the
E
E
F
enters the opening on the
F
has been
E
is on the
F
34
6
A
G
Refer to your vehicle owner's manual to locate the
lower anchor bars on your vehicle seat.
Attach the left hook , or clip
A
bar , and the right hook to the right anchor bar.
G
DOUBLE CHECK that each lower anchor connector
hook or clip is fully engaged by pulling hard on the lower
anchor connector strap.
Correct
IMPORTANT: Make sure both lower anchor Quick Connectors
are facing upward and the straps are not twisted.
7
H
again, find another location for your child restraint, or
install with the vehicle seat belt (page 26). To remove the
lower anchor connector strap, go to page 41.
B
G
, to the left anchor
B
Incorrect
Using your full weight push
the child restraint firmly into
the vehicle seat, while pulling
up on the lower anchor
connector strap
to tighten.
The lower anchor connector
strap must be as tight as
possible. If you can move
the child restraint more than
25 mm (1 in.) side to side
or front to back at the belt
path , the lower anchor
H
connector strap is not tight
enough. You will need to try
35