Organizational Measures; Personnel; Notes On Personnel; Training Operations - Festo CP Factory Manual

1.4.6 Organizational measures

All existing safety devices must be checked at regular intervals.

1.5 Personnel

1.5.1 Notes on personnel

Basically two situations have to be considered, concerning matters on personnel.
 Activities during training operations
 Activities outside training operations

1.5.2 Training operations

Trainees are permitted to work with the machine only under strict supervision of an experienced person or
an instructor.
Activities of trouble-shooting and fault correction are to be checked by the instructor. Special care should be
taken regarding safety aspects.

1.5.3 Outside training operations

Activities in the areas of maintenance, service and repair are to be carried out by only persons with
appropriate technical qualifications.

1.6 Obligations of the operating company

The operating company undertakes to allow only those persons to work with the system who:
 Are familiar with the basic regulations regarding work safety and accident prevention and have been
instructed in the use of the system
 Have read and understood the chapter concerning safety and the warnings in this manual
Personnel should be tested at regular intervals for safety-conscious work habits.

1.7 Obligations of the trainees

All persons who have been entrusted to work with the system undertake to complete the following steps
before beginning work:

Read the chapter concerning safety and the warnings in this manual

Observe the basic regulations on occupational safety and accident prevention.
© Festo Didactic CP Factory / CP Lab ° application module drilling
General safety instructions
9