Flarm Settings; Flarm Track; Osd - Team Blacksheep CROSSFIRE Manual

Status display
If you own a Standard or Lite Tx, you can see the actual status of your FLARM setup in one of the main
screens of the OLed display:
Settings
You can find the FLARM settings under ​ D iversity Receiver/General:
FLARM
Here you can set up which pilots you want to see (OSD and Mission Planner) and if you want to send you
position to other pilots as well:
● Off:​ No FLARM data will be send or received
Pulse:​ Just send out your position
●
● Buddy:​ Send your position and show Crossfire pilots (only available with active license)
Aviation​ : Send your position and show Crossfire pilots and airplanes and helicopters (only
●
available with active license)
Flarm Track
● Off/ On - Send your data to the ground stations. If activated you can be seen on maps like the one
from ​ O penGliderNetwork​
OSD
If you own a TBS Core Pro or a FPVision OSD, they can show you the received pilots in a radar which scales
by itself. If no other pilot is found, the radar will disappear and come back when a new pilot is found.
The shown Types depend on your license and the FLARM setting you have set up before.
Status:​ no Sat Fix/ Fix - are enough satellites
found by the GPS
Transmitter: ​ A ctive/ Inactive - #TODO
Receiver:​ Active/ Inactive - Active if a license is
installed
Req. Upd. by​ : XX.XX.XXX - Will be updated by the
Crossfire updates
.
74